Modification, remixing, and commercial use of this data are strictly prohibited.

If you wish to sell prints, please obtain a commercial license from here
[https://www.patreon.com/cw/Manabun_lab](https://www.patreon.com/cw/Manabun_lab)

A minimalist Switch Pro controller stand that combines lightness with high rigidity.
It achieves this by stripping away the unnecessary.

By placing the center of gravity slightly toward the rear, it reduces wobble and tipping when set down, delivering exceptional stability on your desk.
Because it requires no supports and can be printed in about 39 minutes, it’s suitable for mass production.
Experience the satisfying “click” as it snaps into place.
It cannot be used with the Switch2 Pro controller because its size is slightly different.
Switch2 Pro controller stand is here:
[https://makerworld.com/en/models/2597626](https://makerworld.com/en/models/2597626)






Switch Single Joy-Con Grip

[https://makerworld.com/en/models/570404](https://makerworld.com/en/models/570404)

Switch Joy-con Grip 2025
[https://makerworld.com/en/models/579623](https://makerworld.com/en/models/579623)