Modification, remixing, and commercial use of this data are strictly prohibited.

If you wish to sell prints, please obtain a commercial license from here
[https://www.patreon.com/cw/Manabun_lab](https://www.patreon.com/cw/Manabun_lab)

A minimalist Switch2 Pro controller stand that combines lightness with high rigidity.
It achieves this by stripping away the unnecessary.

By placing the center of gravity slightly toward the rear, it reduces wobble and tipping when set down, delivering exceptional stability on your desk.
Its practical design lets you place the controller even with the headphone jack plugged in.
Because it requires no supports and can be printed in about 38 minutes, it’s suitable for mass production.
Experience the satisfying “click” as it snaps into place.
It cannot be used with the first‑generation Pro controller because its size is slightly different.
First-generation Switch Pro controller stand is here:
[https://makerworld.com/en/models/2597644](https://makerworld.com/en/models/2597644)


 

Switch２ Single Joy-Con2 Grip is here:
[https://makerworld.com/en/models/1495439](https://makerworld.com/en/models/1495439)


 Nintendo Switch 2 Joy-Con 2 Snap-Lock Grip is here:
[https://makerworld.com/en/models/1514088](https://makerworld.com/en/models/1514088)

Switch2 Handheld Grip is here:
[https://makerworld.com/en/models/1692685](https://makerworld.com/en/models/1692685)