Here is my first version of a laser for the Johnny 5 model at 3/4 of the original size, for those who prefer the look from the first movie and want to replace the toolbox.

Please note: due to the fixed pose of the Johnny 5 model, I had to slightly modify the laser arm and add an additional joint. I looked at images of the hero prop and assume that the arm, as it was mounted there, was likely adjusted by hand for fixed positions/scenes.

Yes, this makes it a bit less screen-accurate, but it allows for much better adjustment and positioning on this model. Please excuse any imperfections — this is only version 2 that I designed in Fusion and its not perfekt. Constructive feedback and improvement suggestions are very welcome!

Here is the MakerWorld link for the 3/4 scale model:
[https://makerworld.com/en/models/139824-short-circuit-johnny-5-alexa-holder-3-4-scale](https://makerworld.com/en/models/139824-short-circuit-johnny-5-alexa-holder-3-4-scale)

This model is based on the original version from Thingiverse:
[https://www.thingiverse.com/thing:5541988](https://www.thingiverse.com/thing:5541988)

Big thanks to the original creator — this project is a modified and adapted version of that base model.

For those who don’t want to build the Alexa version and need an alternative chest plate, you can find it here:
[https://makerworld.com/en/models/406534-alternate-chest-plate-for-johnny-5-3-4-scale](https://makerworld.com/en/models/406534-alternate-chest-plate-for-johnny-5-3-4-scale)