I had fun making this model and I hope you have fun building it to! 

Here are the instructions of how to build the model.

Step 1: Put the two rods into the two pipes in the order pictured.

Step 2: Lift up one of the bars just enough so you can see the hole though the slot.

Step 3: Make sure when you glue the pegs that the curve part is facing downward.

Step 4: Glue the pegs in. Hot glue is best.

Step 5: Put the rubberband on like in the picture.

Step 6: Repeat the steps from 2 to 5 on the ather part of the egg.

Step 7: Once both sides are finished put glue in the hexagon pocket and then fit them and push them together enought so that you can barely see a crack .

CONGRADULATIONS  you have completed the LOCKING EGG !!!!!                                                       

congradulations