Having a disabled family member who constantly drops her cane when going in and out of our door, I wanted to find a way to keep it safely standing upright while being easily removed/placed, so it required little to no effort. I designed this holder from scratch in fusion. It is simple, yet effective. Designed for canes with a diameter of around 23mm, it is attached to the wall using two screws, and was anchored to the wall for stability. The inner screw hole is 4mm, and the outer ring so the screw is inset is 7.5mm in diameter. Printed in PETG at 0.2mm layer height 6 walls and 25% gyroid infill. Arachne wallgen was enabled for better layer adhesion in smaller spaces within the model.