P2S Waste Bin
 

This model is a compact waste bucket designed to collect purge material from the P2S printer.
It hangs on the back of the machine and connects directly to the waste exit chute, keeping everything clean and contained without taking up extra space.
 

Installation is simple and doesn’t require any additional hardware.
Using the larger Allen key included with the printer, loosen and remove the screw located at the bottom of the rear poop chute.
Place the 3D-printed washer in between (it works like a small raised hanger piece), then reinstall the same screw to secure it, the bin attaches directly to this hanger.
 

The design focuses on simplicity and efficiency, using only about 45 grams of filament while maintaining a clean and aesthetic look.
It’s an easy-to-print, practical solution to keep your printing area tidy.

In order to print this the filament must be dry, the walls are thin and if the filament is too wet it can cause faulty prints.