This is a snap-fit stand designed for the Stream Deck Mk.II.

The Stream Deck is a fantastic device, but I found the default angles not ideal:

• The device alone is too flat, making the bottom row hard to read (approx. 8°)
• The included stand is too steep (approx. 48°)

This model fills the gap by providing intermediate angles that are more comfortable for everyday use.
If you’ve felt the same issue, this might be a great fit for you.

■ Features

• Three angle options
  • Approx. 24° / 30° / 37°
• Snap-fit design
  • Just insert the device, no tools required (same concept as the original stand)
• Low-profile appearance
  • Minimal visual impact from the front
• Cable-friendly
  • Rear center opening for USB cable routing

■ Compatibility

This model was designed and tested with the 15-key Classic (Mk.II).

It may also work with the Scissor Keys version, but this has not been confirmed.
If you test it, feedback in the comments would be greatly appreciated!

■ Printing Notes

Depending on your printer and filament, the fit may be:

• Too tight
• Too loose

If needed, adjust your slicer settings:

• X-Y Contour Compensation (or similar horizontal expansion settings) is recommended

■ Recommended For

• Users who find the default angle too shallow
• Users who find the original stand too steep
• Anyone looking for a cleaner, low-profile desk setup