Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Description
A basic case for for a W3230 temperature controller. It uses standard sockets so that it can be used in various ways.
After printing, connect all the wiring and snap the module + sockets in place, run the sensor wire out through the hole on the front of the case. I put a knot right behind the hole as a strain relief for the sensor wire. The lid closes with M4x15 countersunk bolts.
You can use this temperature controller for cooling or heating anything as long as it has a 230V schuko/euro plug. Technically you can switch anything up to 2200 Watts, but it's probably better to not drive the relay at max.
Materials used:
Temperature Controller 230V heating and cooling
Publicado em 21 de mar de 2026
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta