A minimalist PC tower stand in the shape of a stylized infinity sign (∞). The stand lifts the tower off the floor, improving airflow underneath the case and keeping it clear of carpet. The looping geometry provides a stable two-point contact footprint while keeping material use low.

The stand shown fits a standard mid-tower case. Scale in your slicer as needed to match your case width.

Print instructions:

Print upright on the infinity shape. Then, no supports are needed. Standard print profile at 0.2 mm layer height is sufficient for structural integrity. For filaments prone to warping, adding mouse ears at the outer corners improves bed adhesion.

• Material: PLA recommended
• Infill: 15–20%
• Supports: None
• Layer height: 0.2 mm