Description
i'm Sharing this with you all because there is some greedy designer out there that don't like you using their frame for your own lightbox designs.

Have fun making your own lightbox plates to fit the frame. 

If you have trouble or would like to me to make the design up for you please feel free to message me.

This model is fully 3D printable and designed for easy assembly with clean lines and simple wiring up.

Features:

230 mm x 210mm diameter

2mm Wall thickness
50 mm total thickness
Double-sided design (visible from both directions)
Includes wall-mount brackets
Hollow bracket arms for hidden LED wire routing
Designed for LED strip lighting
Clean, even light diffusion

Plates have slot for easy line up on the 2 sided frame making sure you get from side in the same position.

i have included a black backing plate in case you only want to make a one sided sign. 

Installation:

The included mounting brackets are hollow, allowing you to run your LED wiring directly through the arm for a clean, professional 

Nice and easy to install by using the hole jig now messy marking up needed.

Mount the brackets using drywall screws or similar with the wiring tunnel facing up for top bracket and down for bottom bracket. (I found it easier to put my wire through before tightening the screws against the wall)

Then slide the lightbox frame onto the mounts and push till it clicks into place.

Next, just remove the adhesive backing strip and route your lights around the inside of the frame as many times as you would like.

The design is intended to be used with your own LED light kit these can be brought online or instore.

Printed in PLA for the example shown but if you are going display your lightbox outside or in the shed i suggest that you Print it out of PETG or ABS

So if your thinking about lighting up your personal area i thank you in advance for giving my lightboxes a look over. im always open to request.