SO last week i uploaded the 3d printed corm screen. well the validity of it was questioned. so i made this ring to put the usual disposable screen on top of a stand.  i figured why not have both and see what works.  this model will “snap” into place in the bottom of your 2 oz cup (modeled off of these off amazon [https://a.co/d/096YRUev](https://a.co/d/096YRUev) )  if you have other cups you may have to play with your scaling in your slicer a little bit.  I printed at 50% infill so its nice and solid.  I printed in PLA+ and it should be fine.  let me know what yall think and enjoy!!!