A mini scraper to remove those thin layers & calibration lines without the need for breaking out a large scraper. I find a gentle knock to the edges is all that is needed to peel / ping the filament off, and this tool makes that easy. Also deters you from using your fingers, possibly compromising bed adhesion & not to mention that horrible pain when using your fingernail goes wrong!!

I wanted something that could be kept close-by, was small, grab-able, ergonomic to use…..and of course, looks good too. So I have also included two mounting methods:

1. Using the empty USB hole on the top of all P1P and P1S models. when docked here the tool is always on hand when needed and looks neat too.
2. Using a magnet press fitted into the bottom hole provided. The hole is sized for a 10mm x 3mm magnet which is a fairly common size.

Print profile titled ‘USB Dock’ incorporates both these mounting methods and the scraper is 240° round (so it can rest nicely on the printer).

Print Profile titled ‘MAG Round’ has just the magnet hole mounting method and the scraper is 360° round.