You asked, I delivered.

Leafpool!

Now there are a few different versions of her that I have seen in terms of her appearance so here are some suggestions.

This design I made has a lot of filament changes so I took the time with my poor painting skills to handpaint one to give you an idea of what you can do. Along with that, Im including two profiles. One that is standing upright and one laying down. The one laying down has a lot LESS filament changes BUT as you know, there will be some markings from the raft it is laying on when printing. If you are displaying one side of it than this may not matter, or you can always paint over imperfections. My suggestion is that if your considering a lay flat version, try printing it in your cheapest filament and ONLY PRINT the bottom part of the print and see what the quality is on your printer. Yes you will have to scrap this but it saves you time and more expense on doing a whole print on its side that you end up tossing. If you only print the bottom part you could always get crafty and glue it to a board or frame as a 3d Art piece also.

In addition, you can remove the colors in the slicer. You will see in these photos I have a two color version I hand painted and then a 2 color version I didnt paint. Gives you an idea of visuals. The world is your pallete!