Layered: [https://makerworld.com/en/models/1484536-team-rocket-pokemon-tcg-deck-box#profileId-1550713](https://makerworld.com/en/models/1484536-team-rocket-pokemon-tcg-deck-box#profileId-1550713)
Alchaan: [https://makerworld.com/en/models/2017236-pokemon-deck-box-insert#profileId-2173651](https://makerworld.com/en/models/2017236-pokemon-deck-box-insert#profileId-2173651)
Rodaroid: [https://makerworld.com/en/models/2237897-insert-box-deck-team-rocket#profileId-2435588](https://makerworld.com/en/models/2237897-insert-box-deck-team-rocket#profileId-2435588)

This file is a combination of Alchaan's original insert design and Rodaroid's edits, with a few additional modifications. It is intended to be used with Layered's Team Rocket deck box. I use Dragon Shield sleeves so that was my main point of reference for the card holder, but I assume it should work fine for the smaller Pokemon ETB sleeves, etc.

Note: there are two profiles to select from, a “regular” and “XXL” version. I bought some official Team Rocket dice and found they were a bit bigger than other Pokemon dice, and I couldn't get them to fit into my original version. So I made a quick XXL version that just increases the size of the dice tray area (also comes with a little dice tray for taking the dice out). It's not perfect but I just wanted to have the option there in case anyone else goes for the Team Rocket dice (you can also just print the dice tray on its own if you wanted to test whether it would be a good fit for your dice).

MAIN CHANGES:
-A slight fillet was added around the perimeter of the top of the insert to help make the box lid a bit easier to close.
-Increased the size of the d6 holder to 17mm, as I found the tolerance too tight for my official Pokemon d6's.
-Added a slight fillet to the damage dice holder to help a bit with taking the dice out.
-Re-added the gap on the left side of the deck holder from Alachaan's original version (removed in Rodaroid's version). Created an extra insert to hold the cards that can be used to pull the cards in and out more easily.*

*Again my reference for the sizing was my 60 card dragon sleeve deck I had lying around. It's been played a fair bit so there's just enough give that you can fit your fingers between it and the holder comfortably. But if you're using a freshly sleeved deck, the air might make the deck a bit taller/harder to fit in. I may revise it in the future based on feedback.