FULLY CUSTOMIZABLE BOOK STAND

An easy to use MakerLab tool to create your own book stand!!

For maximum strength print the model on the side, an example can be looked at in the print profile. Beware the size I used might not fit your specific book (65mm width)!!

With this model I'll always recommend creating your own size. There is too much variation to cover a decent amount of books.

Recommended print details:

Layer Height: 0.2mm

Wall count: 3

Infill: 10%

Please have a cleaned print plate and be accustom to your 3D printer, if your printer is able to print thin and tall models.