A sleek, snap-fit case designed specifically for the RC522 RFID Reader module. Perfect for Arduino/ESP32 projects, home automation, or access control systems.

Features

• Perfect Fit: Tolerances designed for standard RC522 boards.
• Cable Management: Includes a cutout for jumper wires or soldered pin headers.

• Minimalist Design: Low profile to ensure maximum read range through the plastic.

  Print Settings

• Material: PLA or PETG
• Layer Height: 0.2mm works great.
• Supports: No
• Infill: 15-20% Grid.

Assembly Instructions

1. Put the RC522 board into the base.
2. Route your wires through the Back exit port.
3. Snap the lid into place
4. Note: Ensure your pins are at a 90-degree angle to fit this specific version.