All doors have different height, size, thickness. etc
So I made a door stop that is fully customizable.

• You need double tape at the bottom to attach the stopper on the floor at your desired location. Alternatively you can use the velcro type 3M tape to be able to remove the stopper out of the way. (See Bill of Materials)
• The thickness of the door is important. You can measure the thickness of your door and add approx 5mm to it. Because older doors are different thickness at different spots.
• To stop the door you simply open the door until its locked. To release the door you can press the stopper a bit with your feet until the door is released. If you do not have a door closer attached to your door, you will have to manualy pull the door while you press the stopper with your feet.

The orientation is very very important. Following is how it should be placed on the build plate for maximum strength. Dont worry it wont break easily even with PLA.

If you have any issues, let me know and i am here to help.

Happy Printing!