Sideshow Anakin

Sideshow Anakin

Along time ago on a printer far far away…..

Printed in parts, NO AMS needed. Model is approx 27cm tall at 120% in the print profile for ease of assembley. Printing it smaller is possible however small parts will be difficult to print and assemble.

Keep an eye out on my page for future releases comming up in the next few weeks.

📌 Recommended printing settings:

Material: PLA
Layer height: 0.16 mm
Infill: 15%
Nozzle: 0.4mm

supports where nessesary - I have tried to make it so all have a surface contacting the plate however due to the detail and complexity of the modeling they sometimes require alot of support, so be aware and be carefull during support removal. Use a naked flame gentley and for short intervals to clean surfaces after removal

Assembly – Recommended Method on multipart models

Dry fit: Assemble all parts without glue to check alignment and fit.
Cleanup: Lightly deburr edges and pegs where nessesary with a file/modeling tool to ensure uniform contact. All parts are tested and fit together.
Optional fix: Use glue for permanent assembly. This Is Highly Recommended!

Descrição