🛠️ Sunshade Button Mount (Adhesive Plate)

Tired of suction cups falling off your windows or furniture every time the temperature changes? This Adhesive Button Mount provides a rock-solid, permanent attachment point for any accessory that uses a standard "keyhole" or "loop" mounting system.

Size

• Default size is 25x25mm
• Inner button diameter is 9mm
• Outer diameter is 13mm

💡 Why this is better than a suction cup:

• Zero Drops: Once adhered, it stays put. No more finding your sunshades on the floor.
• Low Profile: When the shade is removed, the mount is nearly invisible and won't snag on curtains or clothes.
• Universal Fit: Designed to fit most standard sunshade loops and perforated privacy screens.
• Customizable: Customize sizing to your needs! Just remember to orient properly before printing (best standing at 30° but fully standing should work ok as well.

🖨️ Print Settings

To ensure the "neck" of the button is strong enough to handle tension, I recommend the following:

• Material: PETG or ASA is highly recommended—especially if using this in a car or near a sunny window where PLA might warp from the heat. For regular use should be ok.
• Orientation: Prints with 30 degree angle for maximum strength and lowest support.
• Layer Height: 0.2mm works perfectly.

🔧 Installation Tips

1. Double-Sided Tape: Apply a high-quality VHB tape (like 3M) to the flat back of the plate.
2. Clean the Surface: Use isopropyl alcohol to clean the mounting area for maximum stick.
3. Wait: Let the adhesive cure for 24 hours before hanging heavy shades or applying tension.