Artwork source Pinterest.

Then used HueForge v0.9.3 to create the model.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.

Size is 150x200mm. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.08mm and the Actual Depth is 2.08mm.

It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.

Filaments Used:
PLA Anycubic Black  Transmission Distance: 0.3
PLA Sunlu Meta Grey  Transmission Distance: 3.5
PLA Elegoo Basic White  Transmission Distance: 7
This print uses 3 unique filaments

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Grey
At layer #14 (1.2mm) swap to White for the rest.
 

Share your prints and…