GBRS Lerna XPS mount (EXPS)

GBRS Lerna mount (Holographic)

Eotech XPS (553) / EXPS (558)

I really liked the look of the Lerna mount I saw in a GBRS video, so I decided to design it.
I use it with the EXPS because I don't mind the extra few millimeters but it was designed originally for the XPS.
I used PETG because if I want to play outside I think it will hold up better even in the sun but if you play CQB then PLA works just fine.

With the Eotech XPS the center line sits at 2.91 inch (74mm).

Print settings:
Layer height - 0.28
Infill - 45% / 100% (Optional)
Infill pattern - Gyroid
Speed - 600ms/s (Optional)
Supports - ON
Filament - PLA, PLA+, PETG

Hardware:
M4 30mm bolt x2
M4 nut x2

If you want to support me you can with a boost. Very much appreciated❤️.

Descrição