This back scratcher is the one to rule them all. If you are tired of the tiny back scratchers that bend and break under any real pressure then this is the back scratcher for you. I recommend printing this with PLA BASIC or PLA 2.0 plus. Recommend using a basic 1" wooden dowel from your local hardware or lumber supplier for the shaft. Cut it to suit the length of handle you want and sand the ends smooth. Then use a hair dryer or heat gun to heat up the model and handle tip. Stick the pole in the hole and let it cool. it should be hard together after that. If not pull it apart and use some gorilla super glue GEL. You will want to print this with the high strength settings to get the best scratches possible.