Luna Moth polymer clay cutter with a sharp edge, available in 35mm

I have only tested on Bambu labs and have only use a 0.4mm nozzle, which produces great results. Arachne must be selected.  

Tips

• Roll clay to 2.5mm or thicker for a clean impression
• If clay is sticking, use cornstarch (or water seems to work well) and also do the double press method - press lightly and lift, then press again. (this one is a little more tricky so suggest to maybe try 3 lifts)  

Print settings
0.4 Nozzle
0.16mm layer
2 walls
15% infill but for best results I do often print with 100% infill 
Wall generator 'Arachne'