This model is a custom hanger to mount a Amazon Echo Dot Max (larger device, released in 2026) from under a surface (Ceiling, Cabinet, Shelf, etc).  It may fit other devices, you will need to measure and determine that.

I created this as the new Echo Dot Max is designed to be in the middle of the room since it offers 360 degree sound.  I needed a solution to mount it into my garage and didn't want to use any of the existing wall mounts since from the ceiling made the most sense for my use.

Has a single recessed screw hole through the top.  The top section has the extended core, so you have a place to wrap any excess power cord you need to store depending on how far away you mount it from an outlet.

Print profile is setup for a .4 nozzle, I printed it in PLA, but you could print in anything you like.  I went with 25% infill and tree supports.  The supports were a little tough to get started, but once you do they pop right off (the top of the tree supports creates a raft like interface on this model and came off clean).