Cake pop disc tool in the shape of a game controller

These can also be used by kids with playdoh/kinectic sand

Sizes:
Small (Approximately 44mm)
Medium (Approximately 52mm)
Large (Approximately 60mm)
 

Instructions: 
1. Place the smaller solid part into the hollow part (as pictured). 
2. Place onto the spread out cake mix

3. Press it down on the tabs

4. Lift the tool up and push the solid part in to pop the cake shape out

5. Repeat

Care Instructions:

Since this is 3D printed please make sure you adequately clean and dry by hand after use to reduce bacteria/germs.

See all my cake pop related designs here: [https://makerworld.com/en/collections/7337553-cake-pop-disc-tools](https://makerworld.com/en/collections/7337553-cake-pop-disc-tools)