fridge sprayer

this is a little cap i designed to attach onto any water dispensing fridge to spray the user in the face with water.

to print:

I recommend PLA, PETG or TPU

PLA can warp over time if left in damp conditions, but it only weighs 0.71 grams, so it doesn't really matter if this happens

no supports or brim necessary.

i measured my fridge water dispenser to be approximately 0.68 centimeters in diameter so i added 0.1mm tolerances to each side for a total of 0.7 centimeters. i highly recommend measuring your fridges diameter and using the appropriate scale factor to get the correct size. if you find that the diameter is somewhere in between i recommend taking an estimate in between the 2 scales either side. Some slicers treat full scale as 100 and some treat it as 1 so make sure you compensate for this by putting the decimal point in the correct place

Diameter (cm)	Scale (0.68cm = 1)	Diameter (inches)
0.50	0.7353	0.1969
0.55	0.8088	0.2165
0.60	0.8824	0.2362
0.65	0.9559	0.2559
0.70	1.0294	0.2756
0.75	1.1029	0.2953
0.80	1.1765	0.3150
0.85	1.2500	0.3346
0.90	1.3235	0.3543
0.95	1.3971	0.3740
1.00	1.4706	0.3937

when assembling the piece, ensure that the little slit is pointing outwards unless you want to get your fridge wet (sorry about he blurriness)

if you enjoyed pranking your friends and family please

Descrição