Many people have requested a stack-able garage for the Golf ball dispenser pro. Well… this isn't stack-able, but it is huge! For those of us with larger printers, I present the Expanded Ball Garage. Holding close to 60 balls you'll only need to fill this twice with a standard large basket (100-110 balls) of balls at the range. I printed this on my ageing Ender 5 Plus. 

Coming in at 353mm (ish) tall you will have to angle it right to fit it onto your 350mm wide bed. Printed numbers side down, if you do a filament swap you'll be able to read the numbers … or you can paint them or something I guess. Due to the large size I have added a reinforcing spine which makes the entire spiral pretty strong.

I print everything in PETG and I didn't want to tempt the gods with such a large print, so I took the liberty of adding a generous clearance of 0.4mm to all sides of the mating surfaces. For me it slips in like a glove and has just the tiniest amount of slack. Perfect for me, YMMV.

25/4/2026: I have added an extended version of the new design of garage. Was it necessary? No. Is it better? Maybe, it does have a handle. Will I make a stackable version? Perhaps.

I have also added a standard height version of the new design for your convenience. I will likely move these two to their own listing once they have been priinted

Also check out:
High Clearance Parts: [https://makerworld.com/en/models/2458563-high-clearance-parts-golf-ball-dispenser-pro](https://makerworld.com/en/models/2458563-high-clearance-parts-golf-ball-dispenser-pro)
Stackable Ball Garage: [https://makerworld.com/en/models/2499048-stackable-ball-garage](https://makerworld.com/en/models/2499048-stackable-ball-garage)