Flip-open protective case designed specifically for the TrimUI Brick handheld console. The design adds a slim outer shell while keeping the device pocket-friendly and travel ready.

The case features a left-side hinge that uses a short piece of filament as the hinge pin — no screws or metal hardware required. A friction/snap closure keeps the case securely shut.

An internal slot is included for SD card storage, and the charging port remains accessible while the console is inside the case (recommended to leave open while charging to reduce heat buildup).

Features

• Designed for TrimUI Brick
• No supports required
• Filament hinge pin design
• No additional hardware needed
• Built-in SD card slot
• Charging port accessible
• Snap-fit closure
• Compact, protective shell

SD Card Slot Fitment

Depending on printer tolerances and layer height, you may need to lightly sand or file the SD card slot opening.

Smoothing the layer lines on the entry ramp allows the SD card to slide in and out more easily. A few passes with fine sandpaper or a small file is typically sufficient.

Disclaimer

This model is provided as-is. Fit and performance may vary depending on printer calibration, material choice, and print settings.

This case is intended to provide light protection during normal transport. It has not been drop tested and does not guarantee protection from drops, impacts, scratches, heat, or other damage.

By printing and using this model, you assume all responsibility for any damage to devices or components.