一个智能烟灰缸，4010双风扇，开关孔，另需要1个滤芯！有吸烟习惯的可以常开来净化空气使用！

收到材料耐温限制，需放一些水来熄灭烟头

烟头的温度可达到200℃至300℃（表面温度）和700℃至900℃（中心温度）

上面的烟头放置区放水需确认是否滴水再使用！

上面的烟头放置区放水需确认是否滴水再使用！

上面的烟头放置区放水需确认是否滴水再使用！

1。需要两个4010风扇，如果用一个风扇，需要打印孔堵，优先选配高转速风扇！

2.开关预留一个13X19孔位，如果不需要开关，需要打印孔堵！

3，滤芯可以随意使用，不要超过中排入风口即可，高度不要超过20MM.长宽为130MM,可裁剪废旧汽车滤芯，有条件可以使用小米滤芯进行裁剪！

4，变压器可使用各种符合风扇要求的变压器，放置小于120X120X40MM即可！

5，灯光可DIY都可达到图中效果！

展示图中使用被拆开的老旧室外开关监控变压器12V2A,开关为船型开关，最小款，滤芯使用了一个汽车上替换下来的滤芯进行的裁剪！

An intelligent ashtray, 4010 dual fan, with switch holes, and requires an additional filter! Those who smoke can frequently use it to purify the air!

Due to the temperature resistance limitation of the received materials, some water needs to be added to extinguish the cigarette butts

The temperature of a cigarette butt can reach 200℃ to 300℃ (surface temperature) and 700℃ to 900℃ (center temperature)

Before using the water in the cigarette butt disposal area above, make sure it is not dripping!

Before using the water in the cigarette butt disposal area above, please confirm whether it drips!

Before using the water in the cigarette butt disposal area above, make sure it is not dripping!

1. Two 4010 fans are required. If only one fan is used, the printing hole needs to be blocked. It is preferred to choose a high-speed fan!

2. Reserve a 13X19 hole position for the switch. If a switch is not needed, a hole plug needs to be printed!

3. The filter element can be used as desired, as long as it does not exceed the middle air inlet and its height does not exceed 20MM. Its length and width are 130MM. You can cut old car filter elements, or if possible, use Xiaomi filter elements for cutting!

4. Transformers that meet the fan requirements can be used, as long as they are smaller than 120X120X40MM!

5. The lighting can achieve the effect shown in the picture, even if it's DIY!

In the display image, an old and disassembled outdoor switch monitoring transformer 12V2A is used. The switch is a boat-type switch, the smallest model. The filter element is made by cutting a filter element that was replaced from a car!