UPDATE 6/1/2026: VERSION 2 OF THE MOSASAURUS HAS BEEN RELEASED. CHECK IT OUT HERE!
 

____________________________

THIS IS VERSION 1

 

Brick Mosasaurus 1:1 scale

Use care when removing supports! When assembling, if you use too much force, you will break the pins, clips, and/or joints! If your print tolerances are too tight, try increasing/decreasing the body piece. OR if you already have it printed, try using gentle heat, such as a heat gun (from a few inches away) to warm the plastic, then assemble. Using too much heat will melt your plastic.

You may need to use super glue on the body and tail, as this object is split with connector pieces so it fits on the p1s print bed.