Designed for TBS Source One V6 (Mid / Long Range Builds)

Engineered and flight-tested by LowFly 3D, this component is specifically designed for the TBS Source One V6 platform in mid and long range configurations.

Every part is developed through real flight experience and crash testing to deliver the best balance between:

• 🪶 Lightweight design
• 🛡️ Impact resistance
• 📡 Functional optimization for DJI O4 Pro setups
• ⚙️ Clean and simple installation

These are not decorative parts — they are performance-driven components built for pilots.

🔌 XT60 Front Mount – 25° Optimized Angle

This XT60 mount is designed with a 25° forward tilt to provide a secure and efficient battery connection while improving cable routing and reducing stress during aggressive maneuvers.

The angled position allows for:

• Cleaner battery lead alignment
• Reduced strain on solder joints
• Improved plug accessibility
• Strong and stable connection during flight

Internally, the mount anchors onto the adjacent standoff without increasing overall height.
This low-profile integration ensures:

• No unnecessary stack elevation
• Full compatibility with various capacitor sizes
• No interference with frame assembly or top plate mounting

The design keeps the XT60 firmly positioned while leaving enough internal clearance to install any preferred capacitor configuration without obstruction.

Engineered for clean builds, structural integrity, and practical long-term use.


🧪 MANDATORY PRINTING REQUIREMENTS

⚠️ IMPORTANT – Follow these instructions strictly

Recommended material:

• High-quality TPU 95A
• Filament must be properly dried

Filament humidity:

• Must be between 10% and 15%
• If higher, dry the filament before printing

General recommended settings:

• 3 perimeters minimum
• 100% infill where structurally required
• Moderate printing speed
• Properly calibrated TPU retraction
• Adequate cooling for layer bonding

📌 Do NOT change the model orientation.
Print exactly as shown in the render images.

The orientation is intentionally designed to:

• Maximize layer strength
• Improve impact resistance
• Prevent structural weak points
• Maintain dimensional accuracy

Changing the orientation may compromise the print.

🛠️ LowFly Philosophy

These are not just STL files.

They are pilot-designed performance parts created for:

• Real flight use
• Real crashes
• Lightweight builds
• Clean aesthetics
• Long range reliability

Designed by a pilot. Tested in the field.
Built for serious FPV performance.

⚠️ USAGE & LICENSE NOTICE

This file is provided for personal use only.

• ❌ Commercial use is strictly prohibited.
• ❌ Reselling printed parts is not allowed.
• ❌ Redistributing, modifying, or sharing the STL files is not permitted.
• ❌ Selling physical prints of this design is forbidden.

This design is intended exclusively for private, non-commercial use.

By downloading this file, you agree to respect these terms.

Unauthorized commercial use or redistribution violates the creator’s rights.