Adjustable Expandable Display Riser

Modular 2–3 Piece Set

This modular riser system is designed to maximise display, shelf, cupboard, or desk space with a clean, practical, and adjustable design.

It works well as a display riser for minifigures and collectibles, but can also be used for cupboards, shelves, kitchen cabinets, and general organisation.

The system includes:

• Part 1 – Left
• Part 2 – Middle (sliding section)
• Part 3 – Right (not needed for widths under 360mm)

The middle section slides inside the left or right section, allowing the riser to expand and adapt to different spaces.

Adjustable Range

2-piece setup
180mm to 360mm

3-piece setup
360mm to 540mm

Height Options

Lower riser: 27mm
Higher riser: 54mm

Great for

• Minifigure and collectible displays
• Shelves and cupboards
• Kitchen cabinets
• Desk organisation
• General display areas

Features

• Modular expandable design
• Adjustable width
• Two height levels
• No supports required
• Easy, reliable print

Printing Instructions

• Material: PLA
• Layer height: 0.2mm
• Wall loops: 2
• Infill: 15% (not really used in this design)
• Supports: Not required

Print Times / Material

• Left Riser: 1h 55m / 89g
• Middle Riser: 2h 5m / 97g
• Right Riser: 1h 56m / 89g
• All 3 parts together: 6h / 275g

Print one Left and one Middle section.
Add the Right section if the expanded width is needed.

Notes

• Designed for flat surfaces
• Decorative items not included
• It should be possible to scale if needed, although this has not been tested

Feedback is also very welcome, good or bad. There are lots of possible directions for this design, so I’d love to hear how you use it or how it could be improved.