A drink coaster set based on a RAM HEMI caliper. The set consists of four rotors and a base. One side has a plate that friction fits into the side of the caliper base and the other side has HEMI embossed directly into the caliper.

The center hub is a separate component that can be glued/melted to the rotor. The center hubs do have a good friction fit and would allow different hubs to be swapped out if they weren't glued to the rotor. The center hub is flush to both top & bottom surfaces of the rotors. A component that has the rotor and center hub as one piece has also been uploaded if you don't want to deal with two pieces. I don't have the AMS system yet, so I rely on different components for color variations.

The caliper base allows enough room to add a thin pad or cork to the bottoms of the rotors. The space between the rotors is 4mm so rubber or silicone pads could also be added.

All parts were printed using generic PLA. The screws are basic steel M3x4mm button head screws - printed screws are not provided.

I plan on adding different name plates in the future.