This gridfinity organizer is intended for small bolts, washers, nuts and threaded inserts. All of the bins are blank so you can add your own labels to them and 2 blanks are included. Label step files need to be shrunken by ~0.2mm to fit within tolerances but the ones in the 3mf file are pre-shrunk. A 1x1 bin can fit a 30mm long bolt for larger sizes but will fill up fast if you have more than 10. Most smaller bolts easily fit into a 1x1 bin unless you have a lot of them

All bins and baseplates use 6x3mm magnets to hold together. Only 2 is needed per 1x1 section if you want to save on magnets. Recommend buying a set of 300 magnets per 5x5 grid since 1 full 5x5 grid will need 200 magnets in total if filling each pocket. Some pockets may be loose so a drop of superglue can be used to hold the magnet in place. (recommend liquid instead of gel superglue for a better hold)

Labels are printed at a much smaller 0.08mm layer height with the arachne wall generator. Without this the periods in the labels such as M2.5 will not print

6x3mm Magnets: [https://a.co/d/0g79vBeL](https://a.co/d/0g79vBeL) 

Superglue with Precision Applicator: [https://a.co/d/0aaLg7Bc](https://a.co/d/0aaLg7Bc)