Meet Mr Can, the playful controller stand that looks like a soda can… but holds your gamepad instead.

Designed to fit most modern controllers, this stand combines a minimal cylindrical body with expressive eyes and a bold tongue support that securely cradles your controller.

It’s functional.
It’s fun.
It’s a statement piece for any gaming setup.

Perfect for:

• PlayStation controllers
• Xbox controllers
• Nintendo controllers
• Most similarly sized gamepads

Adds personality to your desk while keeping your controller safe and organized.

🖨 Print Details

• ⏱ Approx. 9 hours
• ⚖️ ~300g filament
• 🎨 4 colors
• ❌ No AMS required
• 🧩 Multi-part assembly
• 🧱 Supports required on the tongue only

⚙️ Print Notes

• Print body upright.
• Tongue requires supports (organic/tree recommended).
• Eyes can be printed flat on the bed for best surface finish.
• Use 0.2mm layer height for smooth curves.
• 15–20% infill is sufficient.

🔧 Assembly Notes

• Glue required:
  • eyes into body recess
  • tongue into slot.
  • Top and bottom ring into body

💡 Design Highlights

• Rounded cylinder shape for stability
• Angled support geometry for better controller balance
• Clean separation of colors
• Wide base for tip resistance