These are interlocking stackable trays with a couple different designs for dividers in the interior. They are designed to interlock and be tied shut with standard paracord for easy travel/moving without fear of dropping and losing something inside. Models include base tray, lid, split tray, and an asymmetrical split tray. Normal size is 20mm tall, the deep versions are 40mm tall. All are 160mmx160mm wide.

I have printed every plate on a P1S using PLA. If your filament isn't dry, you will get some speckles/blobs at seam points. The seam is set to random to avoid an obvious seam line up the side of the model. If you change the model orientation on the plate, make sure to change the bridge direction to be 45 degrees off from the sides of the trays. This ensures a clean print of layer 11. It will print fine without doing so but the bridge on the bottoms of the tray will not print as cleanly.

Plate 1:

• Base Tray
• 89.19g filament
• 1h46m print time

Plate 2:

• Lid
• 68.57g filament
• 1h26m print time

Plate 3:

• Split Tray
• 95.01g filament
• 1h55m print time

Plate 4:

• Asymmetrical Split Tray
• 97.01g filament
• 1h59m print time

Plate 5:

• Deep Base Tray
• 122.63g filament
• 2h17m print time

Plate 6:

• Deep Split Tray
• 133.98g filament
• 2h34m print time

Plate 7:

• Deep Asymmetrical Split Tray
• 137.94g filament
• 2h41m print time