Update 2.1:

Overview of what is new:

1.  Modified the way that the drawer is placed in the battery storage,now it has a system that locks it in place and doesn't fall when moving the storage around. The drawer now it has to be pulled a little bit up when removing the drawer, so the bump doesnt get in the way. The same way but in reverse when putting the drawer down. (Please check the video below)

2. 

   2.  Added dedicated drawers for cell batteries, you can now print only what you need

    

3.Added dedicated drawers for 2032 batteries

4. Better fitting for the caps, no more play

5. Added trough holes on the back to save up on filament

Overview of what is new:

1. I modified the CAP fitting to not be as tight as previous model and not be as fragile, i added text on the caps to be easier to identify which one for 3xA batteries and which one is for 2xA batteries, the holes where the batteries are going trough are a bit bigger and easier to drop the batteries, also i added a little ramp that lowers the chance for the battery to go vertical instead of orizontaly as shown in the picture:

   

    

    

   

    

2. I have adjusted the walls to be taller for the batteries that go trough to not jump out when loading the storage for both storages

   

    

    

   3.  I made the storage bigger and NO LONGER IT JAMS and STORE MORE BATTERIES

   

•  It can fit 35+ 3xA batteries from 32 
• It can fit 30+ 2xA batteries from 28

4. I have added 4 screw holes( also i have added a print profile that you can print the model without the screw holes) that are 4mm in diameter and the hole that goes trough is 3mm thick, so you need the use a screw that is longer than that(thats what i got around the house, if you want them bigger let me know and i will update the profile)

5. I added a second cell battery storage on left side