This is a set composed of a spacer with 18 degrees angle on each side, and two angled brackets that will take place under the keyboard halves.

Those will allow to tilt the two halves of the keyboard over an Apple MacBook Pro 14". leaving the trackpad and Touch ID button accessible.

This is a solution to have a setup as light as possible while traveling, but still have the keyboard tilted.

Warning: the spacer requires the brackets you can find in my other design here: [https://makerworld.com/en/models/2345682-moonlander-brackets#profileId-2564627](https://makerworld.com/en/models/2345682-moonlander-brackets#profileId-2564627)

Those brackets are attached using the original hardware, and will allow to put the spacer in place. This spacer is required to have both halves stable.

The two bottom angled brackets snap in place of the wrist rest.

The spacer must be printed with support to ensure the dovetails are well printed with the top face facing up.

The two brackets don't need support.