Here is the very first 3d block for the item frame I designed, which is a TNT block! This item uses two of the neodymium magnets, but I have also included two extra magnet holes to allow you to add an additional two magnets if you desire (Check the bottom of the description for the link). The magnets are added after the print is finished, at the back where the hexagon shapes are and do not require any superglue to be held in place. Just be sure to insert the magnets in the right direction, so that the block attaches to the item frame correctly!

This model is support free and does require the AMS. While it does use the AMS, I do know that it should not waste much material. I would recommend that you print multiple blocks if you'd like to save as much filament as possible. For a dual extruder printer, there should be very minimal waste with the way I have it set up.

The four different filaments I used are:

El3goo True Red PLA

El3goo Black Rapid PLA+

El3goo Silver Rapid PLA+

El3goo White Rapid PLA+

The link for the magnets, and the item frame itself, can be found here:

[https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479](https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479)