Mini Toolbox Bluetooth Speaker riser

I wanted to create the viral mini toolbox Bluetooth speaker that I've been seeing online. When purchasing the speakers without doing much research, I ran into an issue. I purchase the 5.25 Orion speakers, and they don't fit because the cone of the speakers is too wide and hit the rails. I had to modify the cone of the speaker to help make it fit, plus modify the us general mini toolbox. I will link everything I bought from amazon below. There are plenty of videos that will walk you through on how to build this speaker set up. For the top draw I did have to cut most of it out. I cut the whole bottom of the draw plus I also cut the upper piece of the draw connected to the slides. For drill holes centering I used the builtnotbought speaker template. For the lower draw I also use the builtnotbought faceplate template as a reference, but I did move it around so I could fit everything in the draw. If you follow the template the amp sits more in the middle of the draw. I moved it over towards the edge more so the amp will sit as far right as possible. I also moved the template with the voltmeter and On/Off switch to help fit everything in the draw. The template was more for lining up the height for everything than left to right placement. I may make my own template if I make another toolbox speaker.