Hueforge of The fifth element
The photos shows the result in  and a nozzle of 0.4

You can change the X and Y dimensions but do not change the Z dimensions  
You must define the printing parameters indicated in the description below and change the filament at the specified heights.  
You can use filaments other than those indicated, but the result will differ.  
You can use any black PLA
 

Hueforge description

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

The Model is 146.33x200mm in size

You may print at higher layer heights below the Base Thickness of 0.8mm
The Max allowed Thickness is 3.12mm and the Actual Thickness is 2.8mm

    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #00358e PLA BambuLab Basic Blue  Transmission Distance: 4
    #c00d1e PLA BambuLab Basic Red  Transmission Distance: 4
    #fce300 PLA BambuLab Basic Yellow  Transmission Distance: 6
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 5 unique filaments

Swap Instructions:
    Start with BambuLab Basic Black
    At layer #17 (0.84mm) swap to BambuLab Basic Blue
    At layer #23 (1.08mm) swap to BambuLab Basic Red
    At layer #32 (1.44mm) swap to BambuLab Basic Yellow
    At layer #42 (1.84mm) swap to BambuLab Basic Jade White
    At layer #55 (2.36mm) swap to BambuLab Basic Blue for the rest.