This is 4 colour Hueforge of Peterbilt 389.

I uploaded two sizes 200x150 X1/P1/A1 and size 180x135 for A1 Mini.

And .STL with thicker version with no border size 200x150. Swap instructions down below.

Do not adjust the thickness (Z) in your slicer!! The layers will not come out right. You can adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.

If you want stand for this print check out my Simple vertical stand.

For my Hueforge pictures with border choose the version with 3 mm gap.

If you like this picture, you can look at my other car pictures here in this collection: [https://makerworld.com/en/collections/3529230](https://makerworld.com/en/collections/3529230)

Instructions:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Blue Gray  Transmission Distance: 4
    PLA BambuLab Basic Jade White  Transmission Distance: 4.8
    PLA BambuLab Basic Sunflower Yellow  Transmission Distance: 3.2
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Blue Gray
    At layer #11 (0.96mm) swap to Jade White
    At layer #18 (1.52mm) swap to Black
    At layer #19 (1.6mm) swap to Sunflower Yellow
    At layer #24 (2mm) swap to Jade White for the rest.
 

Thicker .STL

Swap Instructions:

    Start with Black
    At layer #10 (0.88mm) swap to Blue Gray
    At layer #13 (1.12mm) swap to Jade White
    At layer #20 (1.68mm) swap to Black
    At layer #21 (1.76mm) swap to Sunflower Yellow
    At layer #26 (2.16mm) swap to Jade White for the rest.