This OpenSCAD generator allows you to create a custom 3D printed box that fits your specific card deck perfectly.

• Custom Size: You define the card dimensions and the exact number of cards in your deck.
• Sliding Design: A classic two-part design (Tray + Sleeve) that stays closed with friction.
• Easy Access: Includes finger notches to easily grip and remove the inner tray.
• No Supports: Designed to print flat on the build plate without any support material.

How to Customize

You can use the MakerWorld Customizer or download the .scad file to change these settings:

1. Measure Your Cards

Measure your cards (with sleeves on) to get the best fit.

• Card Height: The length of the long side of the card.
• Card Width: The length of the short side.
• Single Card Thickness: The thickness of one card.
  • Tip: Measure a stack of 10 cards and divide the result by 10 to get a precise number.
• Number of Cards: The total cards in your deck (e.g., 60, 100).

2. Adjust the Fit

• Wiggle: Extra space inside the tray. Keep at 0 for a snug fit, or add 0.5 mm if you want the cards to feel loose.
• Tolerance: The gap between the inner tray and the outer sleeve (changes the friction).
  • Standard (0.23 mm): Good for well-tuned printers.
  • Loose (0.30 mm +): Use this if your prints usually come out a bit thick or if the box is too hard to open.

I used MakerLab to test the code: 
Powered by MakerWorld-Parametric Model Maker (https://makerworld.com/makerlab/parametricModelMaker)