They say love is a boundless, analog emotion that defies measurement. 

They were wrong. 

I’ve successfully taken the chaotic, non-linear variables of affection and mapped them into a discrete, manifold-friendly OpenScad file. By converting "feelings" into a series of 2.5D coordinates, I have achieved what poets couldn't: Love, version 1.0 (Stable Build).

• Love as a Function: I’ve quantized romance at a 0.2mm layer height.
• Resolution of Affection: While others settle for low-resolution gestures, this box features an optimized vertex count, ensuring your devotion is rendered with maximum geometric fidelity.
• Logical Consistency: If love is a bridge, this is a Living Hinge—designed to bend under the stresses of daily life without reaching its ultimate tensile strength.

I’ve calculated the exact surface area of my devotion, sliced it with a 100% gyroid infill for structural support, and exported it as a G-code. It turns out the "Spark" people talk about is actually just the nozzle heating up to 220°C.

⚠️ Warning:

Assembly requires a basic understanding of Euclidean geometry and a tiny bit of glue. Do not over-extrude your feelings. If the box won't close, please check your fold_gap settings and re-level your relationship.

Assembly steps:
1. Connect end-flaps so both are pointing downwards (inside the box)

2. Push connected flaps below point of the hole

3. Now use your thread (or whatever you want to use to tie) so it goes through holes and above flaps

4. Release flaps and fold them again so they have heart shape (stick to the walls properly)

5. Tie your thread now