A mini version of this model can be found here

• Satisfying snappy quick-release mounting
• High poop capacity
• P1S or X1C 
  • Should fit P2S as well, but haven't confirmed. Message me if you want a quick test print.
• No hardware required
• Uses only 50g of filament
• Won't rattle or fall off
• Doesn't interfere with spool holder
• I think it looks pretty cool

I wasn't able to find a poop bucket that checked all my boxes so I decided to take a stab at making my own. To install this, use a 2mm hex key to remove the lower screw from your printer's poop shoot and re-use the screw to secure the included hook/knob to the same screw hole. I recommend tightening with the short end of the hex key to avoid overtightening, it doesn't take much to get a secure hold.

** V2 makes some cosmetic improvements and slight geometry changes. Approximately 1 in 10 poops were taking an errant bounce and overshooting the bucket. That should be resolved, as well as a deeper counterbore to give the mounting screw more thread engagement.