Você está no 3DFinder

Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.

Modelo 3D TL-SG1016PE Network Switch Cable Mount por masheroz no MakerWorld

Descrição

I needed a design that cleanly managed cables while still allowing easy access to the switch. This design lets the switch slide into place so it sits flush with the rack, while integrated channels guide the cables neatly. The result is a stable setup that routes the wires down behind the shelf it rests on. The status LEDs remain clearly visible, and the power cable exits cleanly from the rear.

Assembly is required: the side walls are attached to the top and bottom sections using superglue after printing. I used painters tape to secure while drying. Be sure to us paper to shield the surface on which you're assembling.

MakerWorld

TL-SG1016PE Network Switch Cable Mount

masheroz

Publicado em 7 de fev de 2026

Curtidas

Downloads

Coleções

Impressões

Categoria Office