Ir para conteúdo
3DFinder
Entrar

Você está no 3DFinder

Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.

Buscar mais como este
Modelo 3D Insanity Organizer por YoderPrints no MakerWorld

Descrição

Looking for an organizer that holds literally everything, but theres none out there? Well I'm here to tell you that that will not be a problem anymore! This thing can hold EVERYTHING. And i mean everything. Need something to hold your post-its? Here you go. Need something to hold your push pins? Here you go. Need something to hold your erasers? Here you go. Need something to hold your pencils, pens, sharpies, etc.? Here you go. Now I could write a full essay on everything that thins thing can hold, but that would be a multipage essay and I'm sure you do not want to be reading that.

 

This thing has four drawers, two being the same, where you can store everything. There is two sections on the top for pens, pencils, sharpies, highlighters, etc. There is also an open section where you can put anything but i find it works perfect for post-it notes and a tape dispenser. Also on the side there is a little hook that you can fit scissors on. You can see how i laid everything out in the model photos.

 

This prints in two plates, one with the drawers and the other with the main section. The main plate uses basically the entire print bed so i put brim to make sure the print stuck but also make sure your build plate is clean! If it is not the model may print weird and certain parts may get warped or damaged or just completely fail. You also very much need supports especially for the drawers and the extra hook on the side of the main plate. As long as you do all of this your model should come out looking great!

 

Now you may notice some flaws on mine. There is slight cracking which was my fault because i covered the fan so that layer didnt work very well. Also there is two different shades of blue on mine that is just because i ran out of filament so i had to use a different roll and they were slightly different colors. Finally, the one drawer is not indented as the others are, I fixed that in the final 3mf. 

 

All in all, I hope you guys enjoy! This is one of the bigger models I've made/printed so leaving a boost would be very helpful! Thank you again and enjoy your everything organizer

MakerWorld

Insanity Organizer

Publicado em 5 de fev de 2026

12
Curtidas
11
Downloads
61
Coleções
1
Impressões
Categoria Office
Tags
organizer organization desk Pencil pens pen postit note holder postit note bookmark tape bookmark holder tape holder push pin push pin holder staples staples holder batteries batteries holder eraser eraser holder tools Tool tool holder tools holder scissors scissors holder staple remover staple remover holder sharpie sharpie holder highlighter highlighter holder large office office desk office desk organizer desk organizer organizers
Licença Standard Digital File License
Ver no MakerWorld (abre em nova aba)

Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.

Criar conta