Ditto Yarn Holder(with AMS)

Wasn't it uncomfortable that the thread was rolling while knitting?

I created a yarn holder in the shape of a Ditto to solve the problem in a cute way!

The model is based on a volume of about 220x170x170(mm) and is tested with Bambulab's PLA Matte, PLA Basic.

I recommend using heterogeneous support for output. I printed using Bambulab PETG-HF as a support/lift interface.

The lower part of the metamong is designed to open, and the lid uses x16 6x3 (mm) circular magnets.

In my personal opinion, a 6x2 (mm) magnet would be sufficiently compatible.

The magnet is designed to fit snugly without any free space, so it can be fixed without glue.

However, you can use instantaneous glue if you need it.

If it's hard to push with force, heat the hole slightly with a lighter and insert the magnet to make it go in easily!

Update

2026.03.11_ Ditto Yarn Holder Small Version Output Profiles Added 2 More