This is a model of a container ship that can carry a lot of containers, and can also float. There is a model that requires support and one that doesn't. The containers are also included and they can be stacked up on top of each other. The containers are modular and they also fit on my other boats. This boat does require changing infill (the print files already have these infill changes)

Printing Requirements

This boat needs to have a ballast at the bottom to stay upright. The bottom 10mm of the boat should have 30% cubic infill. 30% cubic infill works best, but if your boat is too heavy or too light, you can change the infill accordingly.

For the model that needs support, you must support the stern of the boat where the “rudder” is, you can use support painting for that. Also, use 3 walls so it is watertight and has a lower chance of leaking water.

Remember the bottom 10mm must be 30% cubic infill or the boat might flip over