Have you ever had your Raspberry Pi overheat on you? Well heres a cooling case for the 3B+!

Settings:

• 0.2mm layer height
• Printed in PLA or PETG
• Needs tiny bit of support on outside piece

Required Materials:

• Requires 6 M4 x 3mm screws, buttonhead looks best
• 12v blower fan found HERE on Amazon

Assembly:

• Two screws hold in board
• Put the fan in, aligning it to the cutout. One screw goes in the pin that the blower slides on
• Two screws go in sides of the lid, allowing it to hinge
• One screw holds the lid down at the back
• Then the blower connects its red and black wires to the rasberry pi on pins 4 & 6 respectively

Happy Printing!